[email protected] www.zeiss.de. Number of the manual: ... 24 On/off switch (not available on lower stand parts for HAL 100 illumination). 25 Release tractor for ...
Carl Zeiss AG is not liable for the performance or the use of these products. Issued by: Carl Zeiss ... E-mail: [email protected] www.zeiss.de ... Therefore, change them only when they have cooled down, and make sure to wear protective gloves ...
ZEISS Axio Imager 2 Pol ... true for the limits of the conoscopic range down to a minimum crystal size of 10 µm. ... Not all products are available in every country.
Zeiss Axio Imager. ... The Mercury lamp should always be first-on and last-off. ... controlled shutters are activated). Mag. NA. Oil? DIC? 5x. 0.15. NO no. 10x. 0.30.
Office: Jl. Radin Inten II No. ... Workshop: Jl. Pahlawan Revolusi No. ... on the drop-down menu or click the right key of mouse in preview area to pop a menu as ...
ao ar livre, use um cabo de extensão apropriado ... dedo estiver apoiado no interruptor de liga/ desliga ao ... On/Off 3 não pode ser travada e deve permanecer.
On high school microscopes, if someone has adjusted the rack stop, the microscope will not focus properly. The microscope rack stop is in place in order to ...
If the field iris is completely shut down it will not allow any light to travel up the microscope to the eyepieces and will result in dark images when looking through ...
When using a compound biological microscope if the stage tends to drift or fall slightly during use, the specimen will not stay in focus. This microscope stage drift ...
(Not Included). Once you have fitted the scope to your desired position, tighten the mount ring down onto the rail. 1. Use an allen wrench to gently loosen the ...
Do not store a microscope without any eyepieces, even if it is covered. This can allow dust to collect within the eye tubes, which can be difficult to clean. If the ...
This lever adjusts the iris diaphragm. Some condensers will have corresponding objective values printed on the condenser (4), while others will not. When using ...
One moves it left and right, the other moves it up and down. ... with in-stage condenser lenses render a sharper image than those with no lens (at 400x).
Condenser lenses are not required on low power (stereo) microscopes. ... lenses too far down and damaging either the objective lens or the microscope slide.
If so, the dirt is on the eyepiece lens (if not, the dirt is internal and you should probably have it cleaned ... This will keep the liquid from running down into the lens.
If no activity occurs after an additional 12 hours, unit will shut down. Pushing either button will return unit to previous brightness and color setting. Illumination.
to as Sabroe Refrigeration - is not liable for damage occurring during ... Shutting down for long idle period . ... Esta señal no debe de ninguna manera suprimirse ...
Serial no. Plant no. Location. RENNER GmbH Compressors. Emil-Weber-Strasse 32 ... Switch compressor on / off. ○ Emergency stop or shut-down of com- pressor. 2 ... S/SLDK-I 2,2 (with pressure vessel), the pressure vessel must be ...
The fundamental function and operation is not affected by this. ... E-Mail: [email protected] ... shut down immediately using the master switch and secured with a.
RICOH IMAGING COMPANY assumes no liability for failure to record ... The level indicator does not operate when the camera is upside down, movies are being ...
10 Mar 2014 ... The information contained herein may not be reproduced in whole or in part without our ... The up/down buttons also control tuner station.
Whenever the high-pressure cleaner is left unattended, the mains disconnect switch must always be switched off. Do not spray against matter containing asbestos ...
Do not use the frequency converter in applications, which ... Converters - Safe Torque Off Operating Instructions. ... Parameter 1-30 Stator Resistance (Rs). 2.
23 Jul 2014 ... E-mail: [email protected] Website: www.globalgilson.com. 740-548-5314 ... NOTE: Bolting the machine down is not a substitute.
Phone: 1300 780 999 Fax: 1300 790 999 Internet: www.altronics.com.au ... this output off, but not affect the time settings so that it can easily be re-initiated by ...
The level indicator does not operate when the camera is upside down, movies are being recorded, or during interval shooting. • The level function becomes less ...
sure that the instruction manual is not damaged by heat or humidity. If the constant climate chamber ... 1.7 Switching off the constant climate chamber in an emergency . ... Sa h off. 5.6.5 Programme mode. In this operating mode, up to 40 freely.
view of clients' limits, the LINE 5.0 tool does not replace every risk tool in the market. ... (SSN) by e-mail [email protected] or by telephone at 55 11 2565-5000 - Option 2. ... Authorized markets are broken down as follows: Authorized ...
No part of this publication may be reprinted, re- produced or ... bed here will not be available until a later date, or may only be ... program to open the Audi connect down- load client. ... The destination lists can be edited or de- leted at any time.
this high-quality product by WINDHAGER ZENTRALHEIZUNG, you have selected a ... Corrosion and sediment resulting from improper heating water are not covered by the ... The blower continues to run until the burner pot has cooled down.
During dispensing, the additional volume (blow out) does not belong to the dispensing volume. 4.5.3. Ejecting the pipette tip. 1. Press down the control button to ...
In the operating status STOVE OFF no automatic pellet burner start is possible, the system is turned off. Emergency operation - heating up without electrical Ignition.
The ETB-IM may not be installed in doors in accordance ... down. Press the assembly assistance firmly into the base rosette. Screw the base rosette with the ...
To avoid interfering with the charging cycle, please do not cut off the power or remove ... Operation 1: Input the VFO frequency directly by the keyboard. Operation 2: ... SCM SE: When scanning and stopping for a signal, will terminate the scan.
batteries, or battery chargers not meeting Paslode specification, size, or quality, improperly ... To remove battery, push down on locking tab and slide battery out.
2 Feb 2019 ... Read this chapter before using the RICOH GR III for the first time. ... Do not use the camera in a place where electrical products, AV/OA devices, and ... If the battery starts to run down more quickly even after being charged, the ...
the Internet at www.stromerbike.com/support. Check which ... If your Stromer S-pedelec does not start, al- ... turning the seat or tipping it upwards or down- wards ...
the thermostat is NOT following ... sensor is damaged or not installed. ... not turn on the floor heating system if the ... Once that device is completely shut down,.
This does not occur while fishing as water helps cool down the motor. If the motor stops, wind manually or move the power lever momentarily back to OFF and then ...
3 Oct 2013 ... TE Connectivity /Tyco Electronics/Raychem make no warranties as to the ... flashing LED indicates that the Processor is cooling down and will switch ... allows the RBK- ILS Processor MK3 to be controlled by external de-.
02.00 | KHM | Assembly and Operating Manual | en | 389171. Imprint ... [email protected] ... Switch off the energy supply, ensure that no residual energy.
Do not submerse the Control Module or expose it to heavy rainfall. It must be mounted off the ground close to the power source. Failure to do so will void the ...
Use the up and down arrow keys to select the required indices and press. F1 to toggle on or off. An index will not turn on if 15 have already been selected. Use F3 ...
29 Apr 2013 ... e-mail: [email protected] Website: www.globalgilson.com. 740-548- ... relocation.” Gilson does not provide calibration services directly, but can provide a ... press <DOWN ARROW ˆ G/N KEY> until menu item.
NOTE: This machine is not intended for use by children. 6. ... hung between two chairs (don't forget to place paper towels or newspaper down in case of ...
