power off the machine and unplug it from the electrical power supply. Contact your Pacojet service provider. It is not permitted to operate PACOJET 2 with a ...
22 Feb 2019 ... b) To do this, use a dry cloth or a cloth moistened only with water. c) Do not use any cleaners, as these alter the taste of the coffee. 1. Lift off the ...
Note: The ON/OFF time ratio does not correspond with the percentage of microwave power, because approx. 2 seconds are needed for heating of the magnetron ...
Changes to the machine not authorized by GRAEF invalidate the present ... Take off removable parts such as chain frame, tray and beater before transport. ... DK Dm. Example: Salami DK = Ø 60. Set semi-circle Dm = 100. DK. 60. Dm. . 100.
Switch off the electrical connection at the socket. The cabinet ... The cooling system is a hermetically sealed system and does not require supervision, only cleaning. If the cabinet ... TEFCOLD A/S, Industrivej 25, DK-8800 Viborg. © TEFCOLD ...
No part of this document may be copied and/or published by means of ... has a heater that ensures that water flowing in does not immediately cool down and re-.
For maximum energy efficiency, leave light off when not viewing your collection. Normal Operating Sounds you may hear. Boiling water, gurgling sounds or slight ...
SHUT-DOWN . ... Do not operate the coffee machine or add-on units until you have completely ... The water connection must have a shut-off cock with a check.
Do not operate where aerosol spray products are being used or where oxygen is being administered. 14. To disconnect, turn all controls to the off ("O") position, ...
Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been ... Pull down lever while holding the end of thread.
Place knives and other sharp-ended objects in the cutlery basket in blade-down position. • This appliance is not intended for use by persons (including children) ...
www.portercable.com ... Sanding of lead based paint is NOT RECOMMENDED due to the difficulty of controlling the ... the tracking knob (2) clockwise (down). 5.
not only on the appearance of the tiles but also on their ... No contienen nada de cemento y poseen un aspecto de pasta ... It is essential that they extend down.
Wait for it to cool down before storing, dismantling or cleaning it. 14- This appliance contains no serviceable parts that can be reused by the buyer. Do not.
LES CATALOGUES BRANDT. CATALOGUE ENCASTRABLE 2020. Télécharger (PDF) ...
Off. Digital Zoom. Off. Compression. Normal. Shadow Adjust. Auto. AF Mode ... to a variety of camera settings, including options not listed in the function menu, display options, and the ... For information on using the software, see online help.
Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, ... website at www.elna.com/support. ... presser foot will go down and the upper thread tension disks will open.
Thank you for purchasing an Olympus digital camera. Before you start to use your new ... Pull the strap tight so that it does not come loose. Joystick. H (left). G (down). F (up). I (right) ... CD-ROM or at http://www.olympus.co.jp/en/support/imsg/.
1 Sep 2010 ... Thank you for purchasing an Olympus digital camera. Before ... Turn off the camera before loading or removing the card. ... The super control panel is not displayed while the shutter button is pressed. ... All other company and product names are registered trademarks and/or trademarks of their respective.
Thank you for purchasing an Olympus digital camera. Before you start to use ... If the indicator lamp does not light, check the USB cable and ... again, or press the shutter button halfway down and ... http://www.olympus.co.jp/en/support/imsg/.
If you do not perform step ② after ①, the ASSIGN LED will turn off after four ... pertaining to our products, please address directly to HORI at [email protected].
not available when offline, which will prevent you from obtaining any new ... Use CANON iMAGE GATEWAY services. [Map] ... NET Framework 3.0 or later (max.
Store firearms so that they are not accessible to ... down and back until seated. Load the desired ... These adapters are available to purchase if not originally.
CL-CBH/EN (1212) 7.5. CombiLine - ... made available by us remain our property and shall not be used (otherwise than for the operation of this ... Johnson Pump Horticulture is part of SPX Flow Technology segment. Johnson Pump ... Serial number of the pump or pump unit are shown on the name plate off the pump and.
Note: Not included on the slave unit / Wire-saving type HG-SC113. 4 MOUNTING ... Press down the rear part of the mounting sec- tion of the unit on the DIN rail ...
24 Jun 2015 ... Do not expose the torch or fuel to temperatures exceeding 120°F/49°C ... down to fill. Gas Torch Tip (F). Soldering Tip (K). Hot Air Blower is the.
to the ignition (ON) wire which does not drop voltage when the starter ... Auto Timer Mode automatically calculates a suggested count down time for your vehicle ...
Do not use the subwoofer in a bathroom, anywhere where it will be exposed to rain, ... it or subjecting it to impact can damage it or cause the battery to run down.
Ensure the television is not placed on top of the power cable as the weight of the ... Program/Channel up and menu up. Program/Channel down and menu down.
The following are trademarks for one or more DEWALT power tools: the yellow and black ... Do not use the power tool if the switch does not turn it on and off.
within it is not to be communicated to a third party, without the prior written consent of Kongsberg ... Output of depth straight down in NMEA 0183 DPT format.
WARNING:Do not hang bags on the handle, as this will affect the stroller's ... to rear of front leg and push the lock down ... email: [email protected].
3 Apr 2012 ... Designed for those applications requiring no vertical displacement - for ... down. Be careful not to squeeze your hand in the moving VR Drive ...
Do not pull or push fabric while stitching. It may deflect the needle causing it to break. • Wear safety glasses. • Switch the sewing machine off (“O”) when making ...
Some settings are not adjustable depending on your model and have been Factory Set. ... 5 Continue moving the coil up and down until the ground noise has ...
http://www.sonymobile.co.jp/support/use_support/ · product/so-02f/ ... where radio waves do not reach the terminal, ... Note down the information saved in the.
transport data logger are not possible with the testo ... 0 to 100% (not for condensing atmospheres)1 ... Button Start: hold down the START key for > 3 seconds.
TRUE/FALSE. TRUE/FALSE. Black. Red. Blue. Green. AND TRUE/FALSE. 2. 01. Challenge Card. Face Up. (Power Source). Face Down. (NOT a Power Source).
To prevent personal injury caused by abrupt start of the sewing machine, carry out the work after turning OFF the power switch and a lapse of 5 minutes or more. • ...
that you will not trust any safety mechanism, you will be vigilant about keeping your finger off ... No safety component can keep your finger off the trigger and the.
if you frequently pump down from atmospheric pressure. The mist filter will trap the oil exhausted from the pump: you can re-use the oil if it is not contaminated.
It is not necessary to press down hard to make the saw cut. Pushing the saw too hard will slow the engine and cutting will actually be more difficult. Note: Some ...
Universal VR Remote Controller. Model #: VRRC ... Requires 2 AAA batteries (not included). Trigger/Enter Button ... C/D - Volume. Joystick Down/Up - Rwd/FF.
To ensure that baby's back is evenly supported, do not put more than one nappy on the baby and make sure the nappy is not folded thickly at the back. • Do not ...
www.purelogic.ru ... [email protected] ... The operator has not been rigorously trained or authorized by the studio units or individuals, can not open the control ...
